Remington Replacement Shaver Head Set — Foil & 2 Cutters for F44900/F55800/F77800, Washable Close Shave

If your Remington shaver has lost its edge, replacing the foil and cutters brings back consistent, smooth results. This three-stage cutting assembly uses an intercept trimmer plus two flexible foils to handle longer hairs and finish with a close shave. The parts are washable, simple to install, and Remington recommends swapping them approximately every six months for optimal performance.

How does this replacement set improve my daily shave?

Worn screens and dull cutters reduce efficiency and can tug hairs, causing longer shave times and uneven results. Installing fresh components restores the shaver’s intended three-stage system, so the intercept trimmer shortens longer strands while the twin foils deliver a finer finish.

• Replaces one screen and two cutters for the three-stage cutting system
• Intercept section trims longer hairs before foil blades cut
• Two flexible foils adapt to facial contours for even contact
• Helps prevent pulling and reduces rework passes

What maintenance is required after installing the new foil and cutters?

Keep the head assembly free of trapped hair and residue for steady performance. The components are designed to be rinsed under running water; allow them to dry fully before reattaching. Replace the set about every six months, or sooner if you notice decreased closeness or increased tugging.

• Rinse under faucet to clear trapped hair and foam
• Air-dry completely before reinstalling on the shaver
• Replace every ~6 months depending on frequency of use
• Consult your shaver manual for correct part numbers and fitting tips

Will these parts fit my Remington shaver model?

These replacement components are compatible with Remington F44900, F55800, and F77800 series (also listed as F4900, F5800, F5800DS, and F7800 in some documentation). Double-check your shaver model against the manual or product label to confirm the correct match before purchasing.

• Compatible with F44900 / F4900, F55800 / F5800 / F5800DS, and F77800 / F7800
• Designed to drop into the same head frame as the original parts
• Refer to your device manual for part numbers and installation steps
• Not suited for unrelated Remington models—verify fit first

How easy is installation and cleaning after replacement?

Installation is straightforward and meant for at-home maintenance: remove the old head, snap the new cutters and foil into place, and you’re set. Cleaning is just as simple—rinse the head under water and let it air dry to keep blades performing well between replacements.

• Tool-free installation: snap-in cutters and screen
• Washable head makes routine upkeep fast
• Dry fully to prevent moisture buildup and prolong life
• Follow manual instructions for safe removal and reassembly

Who is this for? This replacement foil and cutter set is ideal for Remington shaver owners who want to restore original cutting performance without replacing the entire device. It suits men who shave regularly and expect a close, consistent finish, people who prefer a washable, low-maintenance grooming routine, and anyone seeking a cost-effective refresh for F44900, F55800, or F77800 series shavers.